Changelog for SimplexMotionTool PC software.
Version 0.3.6
Tool Tip baloons are added for short explanation of registers
Link to Motor and Simplex Motion Tool manuals are added
A warning if the firmware and the motor model doesn't match is added 
The graph in the Run tab isn't cleared when changing tabs (it is only logging data when the Run tab is active)
New register files added (1.08 - 1.11)
API and software updated to run on standard .net framework included in Windows 10
Various bug fixes

Version 0.3.5
General bug fixes. 
Increased stability when changing target address/searching for other motors on the serial port.
Improved installer.
New Events page.
New register file (SimplexMotionRegisters_p01.07) for future motor parameters.

Version 0.3.4c
Bug fixes.
New register file (SimplexMotionRegisters_p01.06) for future motor parameters.

Version 0.3.3
Bug fix;
Events used in the setup tab when using digital target input had an error. After homing/ start/stop input activated the motor needed to get input 1-4 change to trigger the motor to start its first movement. 
Before
In1	In2	In3	In4	Wanted speed	Actual speed	State
0	0	0	0	100 rpm		0 rpm		After start/stop input activated
1	0	0	0	X rpm		X rpm		Change one of the inputs
0	0	0	0	100 rpm		100 rpm		Set all to 0 again and it moves according do settings
Now
It will move directly after start/stop input is activated.

New;
Added popups to confirm that buttons are pressed in the registers tab.
Added warning popup if user do not have the right parameter file in its folder.


Version 0.3.2
New;
"Setup" tab added. Used for simple standalone settings for Simplex Motion motors.
Needs parameter version 1.05 or later to work as it uses registers 510-540 to store values.
It also utilizes the event registers, so it can’t be combined with user’s own event programming.