SH-Series

Home Integrated Servomotors SH-Series

SH-SERIES – SMART OPEN FRAMED INTEGRATED SERVOMOTORS

The drive unit is controlled by a data bus, such as USB,Modbus RTU (RS485) or CANOpen 301. The motors have typically 2-3 times higher peak torque per weight compared to competitors. The device performs closed loop control of speed and position, and supports ramping with controlled acceleration. Protection features guard the device from over current, voltage, temperature and torque.

To facilitate standalone operation the unit also has digital and analog inputs and outputs, as well as encoder input and step motor emulation inputs. There are configurable features for simple control interfaces using buttons and potentiometers for standalone applications.

SH100

  • Continuous output of 160W and 0.51Nm torque at 3000rpm
  • Brushless outer rotor motor with peak torque of 2.0Nm
  • Integrated drive electronics with 4096 positions/revolution position sensor
  • PID regulator for position or speed control with torque limit
  • Ramp control of speed or position
  • Protection features for current, torque, voltage and temperature
  • USB full speed interface
  • Serial interface RS485 with Modbus RTU protocol
  • CANOpen 301 interface
  • Quadrature encoder input for application use
  • Interface signals for step motor emulation (step/direction)
  • Up to 8 digital inputs and 4 analog inputs
  • 4 digital outputs capable of 50V/1A, with pulse, PWM and RC Servo control modes.
  • PC based software for setup and testing

SH200

  • Continuous output of 300W and 0.72Nm torque at 3000rpm
  • Brushless outer rotor motor with peak torque of 4.0Nm
  • Integrated drive electronics with 4096 positions/revolution position sensor
  • PID regulator for position or speed control with torque limit
  • Ramp control of speed or position
  • Protection features for current, torque, voltage and temperature
  • USB full speed interface
  • Serial interface RS485 with Modbus RTU protocol
  • CANOpen 301 interface
  • Quadrature encoder input for application use
  • Interface signals for step motor emulation (step/direction)
  • Up to 8 digital inputs and 4 analog inputs
  • 4 digital outputs capable of 50V/1A, with pulse, PWM and RC Servo control modes.
  • PC based software for setup and testing

ACCESSORIES

SOFTWARE

This website uses cookies. By continuing to use this site, you accept our use of cookies.