Changelog for SimplexMotionTool PC software.

Version 0.3.5
General bug fixes. 
Increased stability when changing target address/searching for other motors on the serial port.
Improved installer.
New Events page.
New register file (SimplexMotionRegisters_p01.07) for future motor parameters.

Version 0.3.4c
Bug fixes.
New register file (SimplexMotionRegisters_p01.06) for future motor parameters.

Version 0.3.3
Bug fix;
Events used in the setup tab when using digital target input had an error. After homing/ start/stop input activated the motor needed to get input 1-4 change to trigger the motor to start its first movement. 
Before
In1	In2	In3	In4	Wanted speed	Actual speed	State
0	0	0	0	100 rpm		0 rpm		After start/stop input activated
1	0	0	0	X rpm		X rpm		Change one of the inputs
0	0	0	0	100 rpm		100 rpm		Set all to 0 again and it moves according do settings
Now
It will move directly after start/stop input is activated.

New;
Added popups to confirm that buttons are pressed in the registers tab.
Added warning popup if user do not have the right parameter file in its folder.


Version 0.3.2
New;
"Setup" tab added. Used for simple standalone settings for Simplex Motion motors.
Needs parameter version 1.05 or later to work as it uses registers 510-540 to store values.
It also utilizes the event registers, so it can’t be combined with user’s own event programming.